Development of an ombrotrophic peat bog (low ash) reference material for the determination of elemental concentrations

Given the increasing interest in using peat bogs as archives of atmospheric metal deposition, the lack of validated sample preparation methods and suitable certified reference materials has hindered not only the quality assurance of the generated analytical data but also the interpretation and comparison of peat core metal profiles from different laboratories in the international community. Reference materials play an important role in the evaluation of the accuracy of analytical results and are essential parts of good laboratory practice. An ombrotrophic peat bog reference material has been developed by 14 laboratories from nine countries in an inter-laboratory comparison between February and October 2002. The material has been characterised for both acid-extractable and total concentrations of a range of elements, including Al, As, Ca, Cd, Cr, Cu, Fe, Hg, Mg, Mn, Na, Ni, P, Pb, Ti, V and Zn. The steps involved in the production of the reference material (i.e. collection and preparation, homogeneity and stability studies, and certification) are described in detail.     

High frequency monitoring of the coastal marine environment using the MAREL buoy

The MAREL Iroise data buoy provides physico-chemical measurements acquired in surface marine water in continuous and autonomous mode. The water is pumped 1.5 m from below the surface through a sampling pipe and flows through the measuring cell located in the floating structure. Technological innovations implemented inside the measuring cell atop the buoy allow a continuous cleaning of the sensor, while injection of chloride ions into the circuit prevents biological fouling. Specific sensors for temperature, salinity, oxygen and fluorescence investigated in this paper have been evaluated to guarantee measurement precision over a 3 month period. A bi-directional link under Internet TCP-IP protocols is used for data, alarms and remote-control transmissions with the land-based data centre. Herein, we present a 29 month record for 4 parameters measured using a MAREL buoy moored in a coastal environment (Iroise Sea, Brest, France). The accuracy of the data provided by the buoy is assessed by comparison with measurements of sea water weekly sampled at the same site as part of SOMLIT (Service d'Observation du Milieu LIToral), the French network for monitoring of the coastal environment. Some particular events (impact of intensive fresh water discharges, dynamics of a fast phytoplankton bloom) are also presented, demonstrating the worth of monitoring a highly variable environment with a high frequency continuous reliable system.     

The fate of fipronil in modular estuarine mesocosms

The degradation and corresponding product manifold for the pesticide fipronil was determined in three replicate estuarine mesocosms. Aqueous fipronil concentrations rapidly decreased over the 672 h timescale of the experiment (95% removal). Loss was apparently first-order in fipronil, although there appeared to be a change in the removal mechanism after 96 h that corresponded to a dramatic slowdown in its disappearance. The reduction product of fipronil, fipronil sulfide, was not detected in the water column; however, it formed rapidly in sediments and was identified as the major product of fipronil degradation in the system (20% yield at 672 h, with respect to initial fipronil concentration). Fipronil sulfone is thought to form primarily via biological oxidation; and, although it was generated rapidly in the water column (10% yield), only trace amounts were detected in the sediment (1% yield). The direct photolysis product of fipronil, fipronil desulfinyl, was present in all samples; it formed rapidly in the water column (4% yield) and partitioned into the sediment phase (7% yield) over the course of the experiment. The mass balance on fipronil and associated products was 42% at 672 h.     

Concentrations and profiles of polychlorinated biphenyls, -dibenzo-p-dioxins and -dibenzofurans in livers of mink from South Carolina and Louisiana,U.S.A

In South Carolina, U.S.A., mink have been reintroduced from two apparently healthy populations to areas where populations haveexisted in the past but have been extirpated. High mortality wasobserved during transport of mink from the source populations. Inorder to elucidate the potential effects of dioxin-like compoundson the survival and reproduction of mink, concentrations of totalpolychlorinated biphenyls (PCBs), p,p-DDE, dioxin-likePCBs, polychlorinated dibenzo-p-dioxins (PCDDs), anddibenzofurans (PCDFs) were measured in livers of mink collectedfrom the source populations in South Carolina and Louisiana. Concentrations of total 2,3,7,8-tetrachlorodibenzo-p-dioxinequivalents (TEQs) for the South Carolina and Louisiana mink were21 and 14 pg g^-1, wet wt., respectively. PCB and TEQ concentrations were close to the threshold values that can, under laboratory conditions, elicit toxic effects in ranchmink. Therefore, any additional exposures of these populations toTEQs might adversely affect their populations.     

Incorporating natural capital into economy-wide impact analysis: a case study from Alberta

Traditionally, decision-makers have relied on economic impactestimates derived from conventional economy-wide models. Conventional models lack the environmental linkages necessary for examining environmental stewardship and economic sustainability, and in particular the ability to assess the impact of policies on natural capital. This study investigatesenvironmentally extended economic impact estimation on a regionalscale using a case study region in the province of Alberta knownas the Foothills Model Forest (FMF). Conventional economic impactmodels are environmentally extended in pursuit of enhancingpolicy analysis and local decision-making. It is found that theflexibility of the computable general equilibrium (CGE) modelingapproach offers potential for environmental extension, with a solid grounding in economic theory. The CGE approach may be the tool of the future for more complete integrated environment andeconomic impact assessment.     

Distribution of Iron, Manganese, Zinc and Atrazine in Groundwater in Parts of Palar and Cheyyar River Basins, South India

A study was carried out in a part of Palar and Cheyyar river basin to evaluate the current status of iron, manganese, zinc and atrazine concentrations, their origin and distribution in groundwater. Groundwater samples were collected during post-monsoon (March 1998 and February 1999) and pre-monsoon (June 1999) periods from 41 sampling wells distributed throughout the study area. The groundwater samples were analyzed for trace metals using AAS and atrazine using HPLC. The concentration of the trace elements in groundwater is predominant during pre-monsoon period. Distribution pattern indicates that the concentration of these elements increases from west to northeast and towards Palar river. Lower concentrations in the central part may be due to recharge of fresh water from the lakes located here. During most of the months, as there is no flow in Palar river, the concentrations of trace elements in groundwater are high. Drinking water standards indicate that Mn and Zn cross the permissible limit recommended by EPA during the pre-monsoon period. A comparison of groundwater data with trace element chemistry of rock samples shows the abundance of trace elements both in the rock and water in the order of Fe > Mn > Zn and Fe > Zn > Mn. This indicates that iron in groundwater is derived from lithogenic origin. Further, Fe, Mn and Zn have good correlation in rock samples, while it is reverse in the case of water samples, indicating the non-lithogenic origin of Mn and Zn. Atrazine (a herbicide) was not detected in any of the groundwater samples in the study area, perhaps due to low-application rate and adsorption in the soil materials.     

Application of a systemic approach to the study of pollution of the Tinto and Odiel rivers (Spain)

The province of Huelva in the SW of Spain presents high environmental contrasts: together with the great abundance of natural spaces, it shows the impacts of historical natural resources exploitation processes. In the Ria of Huelva, the effluents of the chemical industries must be added to the contaminating inputs of the Tinto and Odiel rivers, coming from the acid drainage of the mines located in the Iberian Pyrite Belt. This forced the Environmental Agency (AMA) to elaborate in 1987 an Effluent Remediation Plan in order to negate unacceptable environmental impacts. The application of a grey box systemic analysis to the AMD pollution, undergone by the Tinto and Odiel rivers has allowed to set a conclusive explanation of the sampling results observed for a period of 11 years, thus making available an overall view of the polluting process and, above all, an explanation of its partial aspects.     

Exposure and inhalation risk assessment in an aluminium cast-house

To date the exposure, absorption and respiratory health effects of cast-house workers have not been described since most studies performed in the aluminium industry are focused on exposure and health effects of potroom personnel. In the present study, we assessed the external exposure and the absorbed dose of metals in personnel from the aluminium cast house. This was combined with an evaluation of respiratory complaints and the lung function of the personnel. 30 workers from an aluminium casting plant participated and 17 individuals of the packaging and distribution departments were selected as controls. The exposure was assessed by the quantification of total inhalable fume with metal fraction and by the determination of urinary aluminium, chromium, beryllium, manganese and lead concentration. Carbon monoxide (CO), carbon dioxide (CO2), aldehydes and polyaromatic hydrocarbons and man-made mineral fibres concentration were assessed as well. In order to evaluate their respiratory status each participant filled out a questionnaire and their lung function was tested by forced spirometry. Total inhalable fume exposure was maximum 4.37 mg m(-3). Exposure to the combustion gases, man-made mineral fibres and metal fume was well below the exposure limits. Beryllium could not be detected in the urine. The values of aluminium, manganese and lead in the urine were all under the respective reference value. One individual had a urinary chromium excretion above the ACGIH defined biological exposure index (BEI) of 30 microg g(-1) creatinine. There was no significant difference in any of the categories of the respiratory questionnaire and in the results of the spirometry between cast house personnel and referents (Chi-square, all p > 0.05). Exposure in cast houses seem to be acceptable under these conditions. However, peak exposure to fumes cannot be excluded and the potential risk of chromium and beryllium exposure due to the recycling of aluminium requires further attention.     

Large-scale mercury variations in Lake Vänern (Sweden) 1974-98

Lake V?nern, the largest lake in Sweden, has been seriously contaminated with mercury during the 20th century. In the 1970's and 80's the direct load, mainly from a chlor-alkali industry in the area, of mercury was drastically reduced as a response to new legislation, from three to five tons down to between five and ten kg yr(-1). Large amounts of the disposed pollutant have accumulated in the sediments. The question posed in this work is now, is the effect of the drastic load reduction after more than two decades visible in the sediments? The question is relevant as large areas still are blacklisted for fishing, but also as a follow-up of a major remedy action. The lake also serves as a freshwater reservoir for even Sweden's second largest city. This work synthesises and compares data of mercury in the sediments from three major field programs, in 1974, 1984 and 1998. The interest is focused on both spatial heterogeneity and temporal trends. In 1974, the surface concentrations are significantly higher than in subsequent surveys. Significant differences are also found between 1984 and 1998. Significant spatial differences within the lake are found for respective year. The most contaminated area is located in the north, close to the major point source (a former chlor-alkali industry). This is also the area with the largest improvement, as a direct response to the reduction in load. Further from the outlet, the recovery is more affected by burial and transport processes out into the deeper basins.     

Examples of the role of analytical chemistry in environmental risk management research

Analytical chemistry is an important tier of environmental protection and has been traditionally linked to compliance and/or exposure monitoring activities for environmental contaminants. The adoption of the risk management paradigm has led to special challenges for analytical chemistry applied to environmental risk analysis. Namely, methods developed for regulated contaminants may not be appropriate and/or applicable to risk management scenarios. This paper contains examples of analytical chemistry applied to risk management challenges broken down by the analytical approach and analyte for some selected work in our laboratory. Specific techniques discussed include stable association complex electrospray mass spectrometry (cESI-MS), gas chromatography-mass spectrometry (GC-MS), split-flow thin cell (SPLITT) fractionation and matrix-assisted laser desorption time of flight mass spectrometry (MALDI-ToF-MS). Specific analytes include haloacetic acids (HAA9), perchlorate, bromate, triazine degradation products, metal-contaminated colloids and Cryptosporidium parvum oocysts.